RLE24

Relays module


 

This DINrail mounted relays module may be used as interface for any I/O board up to max 8 relay outputs with NO and NC contact (code RLE24-8-CLP) or with common signal on each relay (code RLE24-8-CCP).

In the Pixsys range it can be used in combination with  MCM260/ PLE500/ ETD1644.

Using electromechanical relays as switching elements between control device and actuators allows to obtain galvanic isolation and improve the ground connection of the plant as well as the fitting to power fluctuations. Availability of relays 16A with socket for easy replacement enables to increase power in comparison to standard low-power command outputs. 

It is possible to enable/desable locally the single outputs by dip-switch. Input connection to control circuit is possible by flat connector or screw terminal block. 

Surge protection varistor on relay contact is also available. 

Ordering codes

RLE24-8-CCP
INTERFACE 8 RELAYS 24V NPN/PNP - F/N 6SPST-2SPDT 250VAC-16A
RLE24-8-CLP
INTERFACE 8 RELAYS 24V NPN/PNP - 8SPDT 250VAC-16A

Main Features

Input voltage
Relay coil 24VDC
Input connection
Terminal Block max. 8A + Flat connector
Max. relay contact tension/current
250VAC / 16A
Dip-switch to control locally the output
8 pins with remote/local setting
Output Overvoltage Protection
Varistor 275V
Pins number (Control Side)
8
Input current
26mA
Power supply LED with polarity indication
2 Green
Signal LED in parallel to relay coil
8 Red
I/O conductor section
1.5 mm² / 16 AWG
Dimensions (LxWxH mm)
145x93x74
Mounting
Din rail EN50022
Use with SSR Input 24V AC/DC / out 230V 4A AC
Optional

Installation

Dimensioni e installazione

Related products / accessories